Parts handling
Up to Requirements & Wishlist
After trying out the Alpha release I was immediately wishing for a parts library or at the very least a way to input DIN sockets and wire them up. Obviously if the program is heading in the direction of EAGLE then a parts list would be needed to check the traces during testing. If the ability to pretest a circuit is not needed then having DIN sockets would be all we need.
Additionally a breadboard setup that could convert to a PCB would be great. And even a way to handle PCB layouts for off Arduino board applications such as wearable / physical computing.
What does everyone else think?
After trying out the Alpha release I was immediately wishing for a parts library or at the very least a way to input DIN sockets and wire them up. Obviously if the program is heading in the direction of EAGLE then a parts list would be needed to check the traces during testing. If the ability to pretest a circuit is not needed then having DIN sockets would be all we need.
Additionally a breadboard setup that could convert to a PCB would be great. And even a way to handle PCB layouts for off Arduino board applications such as wearable / physical computing.
What does everyone else think?
Powered by
Ploneboard
